You CANNOT use the remote to program a Karr alarm. I've had to deal with those POS alarms at work sometimes, and there are 3 different Karr alarms that use a blank "blocker" clip or one with a button and a LED lens, depending on which one is installed - red button is a 2040 system for cars sans keyless entry or power locks, blue button are 4040 systems that piggyback onto a OEM keyless entry system, and the green button systems are EX-1 shock sensor add-on for OEM alarms.
Accept after tapping the valet button, you will hear 1 honk to confirm steps are completed. If in the future you want the honks back on when you Lock/Unlock your car, do the same thing. Just remember the sequence between POWER on than OFF must be done within 3 seconds. You should hear 2 honks from the horn to confirm "horn honks are off when locking/unlocking via keyfob. Upon pressing it, you should feel a slight click.ġ) Press "POWER" 2 times, then within a second or two, press "POWER" again to turn off vehicle (does not matter if brake is pushed in).Ģ) Tap the "VALET" button 3 times and let go. Usually placed at the lower left corner below the dash (steering column). It is the button immediately behind the flashing led. I also have the HP3 (High Performance 3).īefore you start, make sure your certain you can locate the "valet button" of the alarm system. I've done it to my car and the steps are in the HP3 alarms owner manual as well. Just make sure when you go from turning to "ON", then "OFF," that sequence is done with 3 seconds.
The instructions given thus far are correct.
0 kommentar(er)
